This work presents results of test series, performed for earlier on designed and successfully fabricated silica few-mode microstructured optical fibers (MOF) with six GeO2-doped cores, induced twisting 50 revolutions per meter, typical “telecommunication” outer diameter 125 µm, core diameter 8.7 µm, air hole diameter 4.6 µm, pitch 7.2 µm, and core graded refractive index profiles with height 0.0275. While Part I introduced results of differential mode delay map measurements with laser source excitation / laser-based data transmission over multimode optical fibers (MMFs) with core diameters 50 and 100 µm, combined with 6-core MOF, Part II was concerned with researches of spectral responses, measured for fiber Bragg gratings, recorded in these MOFs, and Part III was focused on laser beam profile measurements, performed for weakly and strong twisted 6-core-MOFs, Part IV reports results of MMF-MOF-MMF fiber optic structure spectral response measurements under direct tension with pull load 0…300 g.
This work introduces first time fabricated spun silica microstructured optical fiber (MOF) with inclusion of seven GeO2-doped capillaries, placed in the central part of MOF cross-section, and induced twisting up to 730 revolutions per meter. Part I discusses technological issues for manufacturing of described complicated twisted fiber optic structure, while Part II presents some results of test series, performed for successfully manufactured twisted MOF pilot samples with typical hexagonal geometry under hole radius 4.40 μm and pitch 9.80 μm, outer “telecommunication” diameter 125 μm, and center part, formed by seven hollow GeO2-doped ring cores with inner radius 2.50 μm, pitch 8.80 μm and refractive index difference Δn=0.030. Following measurements were performed: measurements of transmission spectra under various twisting order, far-field laser beam profiles, some attempts of fusion splicing of typical telecommunication optical fibers and fabricated MOF with insertion loss estimation, and spectral response measurements of both single and group WDM (Wavelength Division Multiplexing)-channels of commercially available telecom WDM-system under inclusion of 2 m length MOF into various spans of short-range lab fiber optic link.
This work introduces first time fabricated spun silica microstructured optical fiber (MOF) with inclusion seven GeO2-doped capillaries, placed in the central part of MOF cross-section, and induced twisting. While Part I discussed technological issues for manufacturing of described complicated twisted fiber optic structure, presented some pilot samples of described MOFs with various twisting order and measured their transmission spectra, Part II describes some results of results of experimental researches, performed for successfully manufactured twisted MOF pilot samples with typical hexagonal geometry under hole radius 4.40 μm and pitch 9.80 μm, outer “telecommunication” diameter 125 μm, and center part, formed by seven hollow GeO2-doped ring cores with inner radius 2.50 μm, pitch 8.80 μm and refractive index difference Δn=0.030 with induced twisting 130, 300 and 730 revolutions per meter. Following test series were performed: measurements of far-field laser beam profiles, some attempts of fusion splicing of typical telecommunication optical fibers and fabricated MOF with insertion loss estimation, and spectral response measurements of both single and group WDM (Wavelength Division Multiplexing)-channels of commercially available telecom WDM-system under inclusion of 2 m length MOF into various spans of short-range lab fiber optic link.
This work presents results of test series, performed for earlier on designed and successfully fabricated silica few-mode microstructured optical fibers (MOF) with six GeO2-doped cores, induced twisting 100 revolutions per meter, typical “telecommunication” outer diameter 125 μm, core diameter 8.7 μm, air hole diameter 4.6 μm, pitch 7.2 μm, and core quasi-step / graded refractive index profiles with height 0.0360/0.0275, respectively. Part I introduces attempts for splicing of typical telecommunication optical fibers and fabricated samples of MOFs by commercially available field arc fusion splicer kits and results of differential mode delay map measurements, performed for laser excited large core (multimode) optical fibers with core diameters 50 and 100 μm, jointed via free space to described above 2 m long pilot samples of 6-GeO2-core MOFs at both receiving and transmitting ends under laser-excited gaussian optical pulse launching with precision offset conditions, while Part II is concerned with researches of spectral responses, measured for fiber Bragg gratings, recorded in these MOFs.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.