We propose and experimentally demonstrate a long-range chaotic Brillouin optical correlation domain analysis by employing an optimized time-gated scheme and differential denoising configuration, where the number of effective resolving points largely increases to more than one million. The deterioration of the chaotic Brillouin gain spectrum (BGS) and limitation of sensing range owing to the intrinsic noise structure, resulting from the time delay signature (TDS) and nonzero background of chaotic laser, is theoretically analyzed. The optimized time-gated scheme with a higher extinction ratio is used to eliminate the TDS-induced impact. The signal-to-background ratio of the measured BGS is enhanced by the differential denoising scheme to furthest remove the accumulated nonzero noise floor along the fiber, and the pure chaotic BGS is ulteriorly obtained by the Lorentz fit. Ultimately, distributed strain sensing along a 27.54-km fiber with a 2.69-cm spatial resolution is experimentally demonstrated, and the number of effective resolving points is more than 1,020,000.
We proposed and experimentally demonstrated a distributed optic-fiber sensor based on the Raman loop configuration and fiber loss characteristic for detecting the temperature and structure's crack. Among them, the Raman loop configuration with reference fiber is proposed to detect the temperature profile along the sensing fiber. It can eliminate the influence of external physical perturbation on the temperature measurement results, and don't require pre-calibration process before measurement. This proposed method improves the engineering applicability of optic-fiber sensors. In addition, the information of crack is detected by using the fiber loss characteristics based on OTDR technology.
A high-speed physical random number generator based on a chaotic laser was proposed and experimentally demonstrated.
The broadband chaotic laser generated by an external cavity laser diode was employed as the physical entropy source.
The chaotic signal was sampled and converted by an 1-bit analog-to-digital converter to a binary sequence with the rate
of up to 1 Gb/s. To overcome the periodicity in random sequence due to the photo round trip time in the external cavity,
the exclusive-or (XOR) operation on corresponding random bits in samples of the chaotic signal and its time-delay signal
from a same single chaotic laser was executed. The scheme was simpler than the present random number generator in
which random number sequences were obtained real-timely by doing XOR operation on the binary sequences from two
chaotic semiconductor lasers. In addition, the proper selection of delay length was analyzed. A large number experiments
show that when the corresponding delay time of autocorrelation trace with correlation coefficient of less than 0.007 is
considered as the delay time between the chaotic signal and its time-delay signal, streams of random numbers can be
generated with verified randomness.
The effects of dispersion on optical fiber chaotic secure communication are numerically investigated. A theoretical model
for fiber chaotic secure communication system which is consisted of a pair of synchronized chaotic lasers and an optical
fiber channel is presented. Chaotic secure communication for a 1-GHz sinusoidal message after propagating several
hundred kilometers is numerically analyzed. By numerically studying the effects of dispersion on the system's
performance, we show that the synchronization progressively degrades and the signal-to-noise ratio of the recovered
message decreases as the fiber length increases. We also find that the signal-to-noise ratio descends when the modulation
frequency of the encoding message increases. We propose a dispersion management scheme to compensate the
dispersion in fiber chaotic secure communication system. The proposed dispersion management map is consisted of a
segment of 5-km dispersion-compensating fiber with value of dispersion β2=-49ps2/km, a segment of 245-km nonzero dispersion-shifted fiber with value of dispersion β2=1ps2/km and optical amplifiers. The results show that the
signal-to-noise ratio of the extracted 1-GHz sinusoidal message increases from 2.75dB to 14.02dB when the length of
fiber is set to 500km.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.