This will count as one of your downloads.
You will have access to both the presentation and article (if available).
Fast and nondestructive quality control tools are important to assess the reliability of photovoltaic plants. On-site inspection is essential to minimize the risk of further damage and electrical yield losses. The most effective way of achieving this is with highly sensitive imaging techniques such as luminescence or infrared thermography imaging. Nowadays, electroluminescence (EL) is used at nighttime to detect defects such as local cell changes, series resistances, and shunts. However, the drawback of this method is low measurement throughput. To increase the throughput, indium gallium arsenide detectors with a resolution of 640 × 512 pixels are used, for which short integration times are possible to acquire EL images. For such short integration times, even moving image acquisition and movie recording are feasible to detect the mentioned defects. An outdoor EL setup is presented for mobile handheld recording, which can even be used under low-light conditions, below 100 W / m2, at daytime. Experiments show that 5 ms integration time is a good compromise between low contrasts for lower integration times and motion blur for higher integration times. The camera prototype has an onboard computer to avoid image transmission losses and an external lithium polymer battery power supply for improved mobility.
The newly developed inkjet printed AgNW percolation network electrodes show high transparency of over 90 % at a sheet resistance of less than 20 Ω/□ and a very low haze of less than 3 %. This enables a clear view through semitransparent devices like organic light emitting diodes (OLEDS) or solar cells in which they can be used.
Therefore this work is focused on light-shaping structures for OLEDs with an internal light extraction layer. Simulations of beam-shaping structures and shapes are presented, followed by experimental measurements to verify the simulations of the most promising structures. An investigation of the loss channels has been carried out and the overall optical system efficiency was evaluated for all structures. The most promising light shaping structures achieve system efficiencies up to 80%.
Finally, a general illumination application scenario has been simulated. The number of OLEDs needed to illuminate an office room has been deduced from this scenario. By using light-shaping structures for OLEDs, the number of OLEDs needed to reach the mandatory illuminance level for a workplace environment can be reduced to one third compared to lambertian OLEDs.
This will count as one of your downloads.
You will have access to both the presentation and article (if available).
View contact details
No SPIE Account? Create one
