23 March 2018 Ultralow-frequency PiezoMEMS energy harvester using thin-film silicon and parylene substrates
Nathan Jackson, Oskar Z. Olszewski, Cian O'Murchu, Alan Mathewson
Author Affiliations +
Abstract
Developing a self-sustained leadless pacemaker requires the development of an ultralow-frequency energy harvesting system that can fit within the required dimensions. This paper reports on the design and development of two types of PiezoMEMS energy harvesters that fit within the capsule dimensions and have a low resonant frequency between 20 to 30 Hz, which is required for the application. A bullet-shaped mass was designed to maximize the displacement and enhance power density of the devices. In addition, two types of devices were fabricated and compared (i) a silicon-based cantilever and (ii) a parylene-C-based cantilever with a thin aluminum nitride layer. The silicon device demonstrated higher peak power of 29.8  μW compared with the 6.4  μW for the parylene device. However, due to the low duty cycle of the heart rate and the damping factors of the two materials the average power was significantly higher for the parylene device (2.71  μW) compared with the silicon device (1.22  μW) per cantilever. The results demonstrate that a polymer-based energy harvester can increase the average power due to low damping for an impulse-based vibration application.
© 2018 Society of Photo-Optical Instrumentation Engineers (SPIE) 1932-5150/2018/$25.00 © 2018 SPIE
Nathan Jackson, Oskar Z. Olszewski, Cian O'Murchu, and Alan Mathewson "Ultralow-frequency PiezoMEMS energy harvester using thin-film silicon and parylene substrates," Journal of Micro/Nanolithography, MEMS, and MOEMS 17(1), 015005 (23 March 2018). https://doi.org/10.1117/1.JMM.17.1.015005
Received: 8 January 2018; Accepted: 6 March 2018; Published: 23 March 2018
Lens.org Logo
CITATIONS
Cited by 27 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Silicon

Heart

Aluminum nitride

Energy harvesting

Microelectromechanical systems

Thin films

Polymers

Back to Top