Mapping stresses in high aspect ratio polysilicon electrical through-wafer interconnects

Himani Sharma; Joshua D. Krabbe; Samira Farsinezhad; Andy C. van Popta; Nick  G. Wakefield; Glen A. Fitzpatrick; Karthik Shankar

doi:10.1117/1.JMM.14.2.024001

17 June 2015 Mapping stresses in high aspect ratio polysilicon electrical through-wafer interconnects

Himani Sharma, Joshua D. Krabbe, Samira Farsinezhad, Andy C. van Popta, Nick G. Wakefield, Glen A. Fitzpatrick, Karthik Shankar

Author Affiliations +

Journal of Micro/Nanolithography, MEMS, and MOEMS, Vol. 14, Issue 2, 024001 (June 2015). https://doi.org/10.1117/1.JMM.14.2.024001

Abstract

Electrical through-wafer interconnect technologies such as vertical through-silicon vias (TSVs) are essential in order to maximize performance, optimize usage of wafer real estate, and enable three-dimensional packaging in leading edge electronic and microelectromechanical systems (MEMS) products. Although copper TSVs have the advantage of low resistance, highly doped polysilicon TSVs offer designers a much larger range of processing options due to the compatibility of polysilicon with high temperatures and also with the full range of traditional CMOS processes. Large stresses are associated with both Cu and polysilicon TSVs, and their accurate measurement is critical for determining the keep-out zone (KOZ) of transistors and for optimizing downstream processes to maintain high yield. This report presents the fabrication and stress characterization of 400-μm deep, 20-Ω resistance, high aspect ratio (25:1) polysilicon TSVs fabricated by deep reactive ion etching (DRIE) followed by low-pressure chemical vapor deposition (LPCVD) of polysilicon with in-situ boron doping. Micro-Raman imaging of the wafer surface showed a maximum stress of 1.2 GPa occurring at the TSV edge and a KOZ of ∼9 to 11 μm. For polysilicon TSVs, the stress distribution in the TSVs far from the wafer surface(s) was not previously well-understood due to measurement limitations. Raman spectroscopy was able to overcome this limitation; a TSV cross section was examined and stresses as a function of both depth and width of the TSVs were collected and are analyzed herein. An 1100°C postanneal was found to reduce average stresses by 40%.

Citation Download Citation

Himani Sharma, Joshua D. Krabbe, Samira Farsinezhad, Andy C. van Popta, Nick G. Wakefield, Glen A. Fitzpatrick, and Karthik Shankar "Mapping stresses in high aspect ratio polysilicon electrical through-wafer interconnects," Journal of Micro/Nanolithography, MEMS, and MOEMS 14(2), 024001 (17 June 2015). https://doi.org/10.1117/1.JMM.14.2.024001

Published: 17 June 2015

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE