Paper
4 March 2015 Burst mode with ps- and fs-pulses: Influence on the removal rate, surface quality, and heat accumulation
B. Neuenschwander, Thorsten Kramer, B. Lauer, B. Jaeggi
Author Affiliations +
Abstract
The burst mode for ps and fs pulses for steel and copper is investigated. It is found that the reduction of the energy in a single pulse (in the burst) represents the main factor for the often reported gain in the removal rate using the burst mode e.g. for steel no investigated burst sequence lead to a higher removal rate compared to single pulses at higher repetition rate. But for copper a situation was found where the burst mode leads to a real increase of the removal rate in the range of 20%. Further the burst mode offers the possibility to generate slightly melted flat surfaces with good optical properties in the case of steel. Temperature simulations indicate that the surface state during the burst mode could be responsible for the melting effect or the formation of cavities in clusters which reduces the surface quality.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
B. Neuenschwander, Thorsten Kramer, B. Lauer, and B. Jaeggi "Burst mode with ps- and fs-pulses: Influence on the removal rate, surface quality, and heat accumulation", Proc. SPIE 9350, Laser Applications in Microelectronic and Optoelectronic Manufacturing (LAMOM) XX, 93500U (4 March 2015); https://doi.org/10.1117/12.2076455
Lens.org Logo
CITATIONS
Cited by 27 scholarly publications and 2 patents.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Copper

Picosecond phenomena

Solids

Pulsed laser operation

Laser applications

Liquids

Oscillators

RELATED CONTENT


Back to Top