Paper
17 October 2014 Particle reduction and control in EUV etching process
Author Affiliations +
Abstract
As the device design rule shrinks, photomask manufacturers need to have advanced defect controllability during the ARC (Anti-Reflection Coating) and ABS (Absorber) etch in an EUV (extreme ultraviolet) mask. Therefore we studied etching techniques of EUV absorber film to find out the evasion method of particle generation. Usually, Particles are generated by plasma ignition step in etching process. When we use the standard etching process, ARC and ABS films are etched step by step. To reduce the particle generation, the number of ignition steps need to decrease. In this paper, we present the experimental results of in-situ EUV dry etching process technique for ARC and ABS, which reduces the defect level significantly. Analysis tools used for this study are as follows; TEM (for cross-sectional inspection) , SEM (for in-line monitoring ) and OES (for checking optical emission spectrum)
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
JeaYoung Jun, TaeJoong Ha, SangPyo Kim, and DongGyu Yim "Particle reduction and control in EUV etching process", Proc. SPIE 9235, Photomask Technology 2014, 92351E (17 October 2014); https://doi.org/10.1117/12.2066297
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Extreme ultraviolet

Photomasks

Inspection

Particles

Plasma

Control systems

Back to Top