Design and fabrication of a low-frequency (1-3 MHz) ultrasound transducer for accurate placement of screw implants in the spine

Amir Manbachi; Mike Lee; F. Stuart Foster; Howard J. Ginsberg; Richard S. C. Cobbold

doi:10.1117/12.2042965

20 March 2014 Design and fabrication of a low-frequency (1-3 MHz) ultrasound transducer for accurate placement of screw implants in the spine

Amir Manbachi, Mike Lee, F. Stuart Foster, Howard J. Ginsberg, Richard S. C. Cobbold

Author Affiliations +

Proceedings Volume 9040, Medical Imaging 2014: Ultrasonic Imaging and Tomography; 90400H (2014) https://doi.org/10.1117/12.2042965
Event: SPIE Medical Imaging, 2014, San Diego, California, United States

Abstract

In 2012 approximately 800,000 spinal fusion surgeries were performed in the United States, requiring the insertion of screws into the pedicles. Their exact placement is critical and made complex due to limited visibility of the spine, continuous bleeding in the exposed regions, and variability in morphologies. The alarmingly high rate of screw misplacements (up to 20%) reported in the literature is of major concern since such misplacements can place the surrounding vital structures at risk. A potential guidance method for determining the best screw trajectory is by the use of real-time ultrasound imaging similar to that used for intravascular imaging. An endovascular transducer could be inserted into the pedicle to image the anatomy from within and identify bone boundaries. A major challenge of imaging within bone is high signal attenuation. The rapid increase of attenuation with frequency requires much lower frequencies (1-3 MHz) than those used in intravascular imaging. This study describes the custom design and fabrication of 2 MHz ultrasound probes (3.5 mm diameter/ 11 Fr) for pedicle screw guidance. Three transducer designs are explored to provide improved sensitivity and signal to noise ratio, compared to the previously tested transducer within the pedicle. Experimental measurements are compared with the results obtained using various simulation tools. The work reported in this paper represents the first stage in our ultimate goal of developing a 32- element phased array that is capable of generating a radial B-mode image.

Citation Download Citation

Amir Manbachi, Mike Lee, F. Stuart Foster, Howard J. Ginsberg, and Richard S. C. Cobbold "Design and fabrication of a low-frequency (1-3 MHz) ultrasound transducer for accurate placement of screw implants in the spine", Proc. SPIE 9040, Medical Imaging 2014: Ultrasonic Imaging and Tomography, 90400H (20 March 2014); https://doi.org/10.1117/12.2042965

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available