Paper
27 November 2012 Design and fabrication of the Y-branch waveguide for optical printed circuit board (OPCB) interconnect
Kang Li, Fufei Pang, Xiaobei Zhang, Tingyun Wang
Author Affiliations +
Abstract
A multimode Y-branch interconnect optical waveguide was designed and fabricated. The transmitting properties of the Y-branch splitter were designed and simulated by using commercial waveguide simulation software. For a 1×2 Y-branch splitter with 50μm×50μm channel waveguide, the relationship between insertion loss and splitting angle was calculated. According to the theoretical result, a multimode Y-branch waveguide was fabricated based on a UV-lithography method on the printed circuit board. To balance the trade-off between the insertion loss and the component size, the Y-branch waveguide was designed of two sections with different splitting angles. An insertion loss of 0.36dB was obtained theoretically with a 5cm Y-branch waveguide.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kang Li, Fufei Pang, Xiaobei Zhang, and Tingyun Wang "Design and fabrication of the Y-branch waveguide for optical printed circuit board (OPCB) interconnect", Proc. SPIE 8555, Optoelectronic Devices and Integration IV, 85551J (27 November 2012); https://doi.org/10.1117/12.999919
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Multimode fibers

Optical fibers

Optical printed circuit boards

Optical design

Channel waveguides

Telecommunications

Back to Top