Paper
24 March 2008 Influence of image processing on line-edge roughness in CD-SEM measurement
Author Affiliations +
Abstract
The necessity for and validity of the bias-free line-edge roughness (LER) evaluation are examined. In a typical case, the LER obtained by the conventional method is found to contain 10% or more bias caused by noise. That is, the biasfree LER evaluation is needed to achieve absolute measurements. The bias-free method is also shown to be necessary in relative LER measurements. Moreover, the impact of the smoothing (i.e., averaging the signal intensity in x-direction) process on the LER obtained from scanning electron microscope (SEM) image was evaluated quantitatively by using the bias-free LER evaluation algorithm. We found that the smoothing broadens the SEM signal profile and causes a change in the LER value. Under practical conditions, his smoothing-induced LER change was 0.4 nm in the sample used for this study. This can be a large error when measuring a small LER. Finally, a procedure for optimizing the smoothing number used for applying the bias-free LER application was proposed by considering the validity limit of the application and smoothing-induced LER change.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Atsuko Yamaguchi and Jiro Yamamoto "Influence of image processing on line-edge roughness in CD-SEM measurement", Proc. SPIE 6922, Metrology, Inspection, and Process Control for Microlithography XXII, 692221 (24 March 2008); https://doi.org/10.1117/12.775664
Lens.org Logo
CITATIONS
Cited by 16 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Line edge roughness

Smoothing

Scanning electron microscopy

Samarium

Image processing

Image analysis

Signal processing

Back to Top