Bootstrap calibration of an autocollimator, index table and sine bar ensemble for angle metrology

James R. Pekelsky; Lorne E. Munro

doi:10.1117/12.618611

18 August 2005 Bootstrap calibration of an autocollimator, index table and sine bar ensemble for angle metrology

James R. Pekelsky, Lorne E. Munro

Proceedings Volume 5879, Recent Developments in Traceable Dimensional Measurements III; 58790D (2005) https://doi.org/10.1117/12.618611
Event: Optics and Photonics 2005, 2005, San Diego, California, United States

Abstract

An in-situ bootstrap method used at NRC to calibrate an ensemble of instruments for angle metrology traceable to international standards for angle and length is described. No prior knowledge is assumed, beyond nominal values with arbitrary large uncertainty, for the index-table step angles, the autocollimator scale factor, and the sine-bar length. Only the sine-bar displacements are known as calibrated values with uncertainty traceable to the SI unit for length. First, the nominal-length sine-bar is used to check the autocollimator linearity, stability, and estimate a nominal scale factor, thus giving a first-iteration improvement in the uncertainty of autocollimator readings. Then, the index table (and a polygon) are measured by a full-closure method at the polygon intervals, and index steps of one interval are measured by the caliper method, with results expressed using improved autocollimator readings. This provides improved index angles. Finally, the autocollimator beam is aimed obliquely at the sine-bar mirror, and the beam deflects to the index-table mirror, where it retroreflects back to the autocollimator via the sine bar. As the index table is stepped through a sequence of angles (with improved uncertainty), the sine-bar angle is adjusted in opposite rotation to produce a zero reading by the autocollimator, and the required sine-bar displacement recorded. This provides a better estimate of the sine-bar length. The steps can be re-iterated--hence bootstrap--to further improve the calibration of each device, until a limit is reached. In recent years, we have linked the data from the three setups in a single spreadsheet analysis, allowing the calibration variables to be jointly and optimally adjusted with just one data run through the three setups. Results using a Moeller-Wedel Elcomat HR autocollimator, a Moore 1440 index table and the NRC sine-bar interferometer are presented, along with an uncertainty analysis.

Citation Download Citation

James R. Pekelsky and Lorne E. Munro "Bootstrap calibration of an autocollimator, index table and sine bar ensemble for angle metrology", Proc. SPIE 5879, Recent Developments in Traceable Dimensional Measurements III, 58790D (18 August 2005); https://doi.org/10.1117/12.618611

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available