Error budgets for the image degradation of x-ray telescope onboard Astro-E2

Kazutami Misaki; Ryo Shibata; Yasuhiro Hidaka; Hideyo Kunieda; Manabu Ishida; Hirohiko Honda; Yoshitomo Maeda; Takao Endo; Kohsuke Imamura; Yoshito Haba; Kei Itoh; Hideyuki Mori; Ryo Iizuka; Akira Hayakawa; Taijiro Morihisa

doi:10.1117/12.461355

11 March 2003 Error budgets for the image degradation of x-ray telescope on board Astro-E2

Kazutami Misaki, Ryo Shibata, Yasuhiro Hidaka, Hideyo Kunieda, Manabu Ishida, Hirohiko Honda, Yoshitomo Maeda, Takao Endo, Kohsuke Imamura, Yoshito Haba, Kei Itoh, Hideyuki Mori, Ryo Iizuka, Akira Hayakawa, Taijiro Morihisa

Author Affiliations +

Proceedings Volume 4851, X-Ray and Gamma-Ray Telescopes and Instruments for Astronomy; (2003) https://doi.org/10.1117/12.461355
Event: Astronomical Telescopes and Instrumentation, 2002, Waikoloa, Hawai'i, United States

Abstract

X-ray telescopes (XRTs) of nested thin foil mirrors were developed for Astro-E, the fifth Japanese x-ray astronomy satellite. Although the launch was not successful, the re-flight of Astro-E mission is approved as Astro-E2 and will carry the same XRTs. Ground-based calibration of Astro-E XRT revealed that its image quality and effective area are somewhat worse than what are expected from the original design. Conceivable causes of these defects of the XRT performance (i.e., surface roughness, waviness, misalignment of reflectors, and so on) are examined by X-rays and optical microscopic measurements. In this paper, we distinguish quantitatively these causes to limit the performance of the Astro-E XRT. Using the detail measurements, we can attribute both degradation of the image quality and a deficit of the effective area from the design values mainly to a slope error with a mm scale in each reflector and shadowing effects of neighboring reflectors due to various factors. There is still room for improvement in the support system of reflectors (i.e., alignment bars) in the XRT. One of the main aims of the mirror system calibration is to construct response function. Therefore, it is important that the development of a representative numerical model and its validation against extensive ground-based calibration. Taking account of the results of the pre-flight calibration and the microscopic measurements, we develop and tune a ray-tracing simulator which constructs the XRT response function for a point source at an arbitrary off-axis angle and spatial distributions of celestial X-ray sources.

Citation Download Citation

Kazutami Misaki, Ryo Shibata, Yasuhiro Hidaka, Hideyo Kunieda, Manabu Ishida, Hirohiko Honda, Yoshitomo Maeda, Takao Endo, Kohsuke Imamura, Yoshito Haba, Kei Itoh, Hideyuki Mori, Ryo Iizuka, Akira Hayakawa, and Taijiro Morihisa "Error budgets for the image degradation of x-ray telescope on board Astro-E2", Proc. SPIE 4851, X-Ray and Gamma-Ray Telescopes and Instruments for Astronomy, (11 March 2003); https://doi.org/10.1117/12.461355

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available

Members: $17.00

Non-members: $21.00 ADD TO CART

PROCEEDINGS
12 PAGES

DOWNLOAD PAPER SAVE TO MY LIBRARY

GET CITATION

RIGHTS & PERMISSIONS

Get copyright permission Get copyright permission on Copyright Marketplace

KEYWORDS

Point spread functions

X-rays

CCD image sensors

Image quality

Sensors

Calibration

Surface roughness

Show All Keywords

Keywords/Phrases

Search In:

Publication Years