Presentation
3 August 2021 Organic radiation detectors for real-time dosimetry
Author Affiliations +
Abstract
Here, we report on an all-organic solid-state radiation dosimeter patterned onto a plastic substrate that allows for real-time measurements communicated over WiFi. The “sense” area and the conductive traces are made using low-conductivity PEDOT:PSS, and measurements are read out by a low-current op-amp. As the detector is subjected to radiation, the ionized air, substrate, and sense area cause a charge accumulation which is then read out as a voltage from the op-amp. OFETs on either side of the sense area allow for the charge to be cleared, allowing for accurate dose measurement without saturation. Additionally, the inclusion of a PEDOT:PSS ground plane as the first layer on the PEN substrate helps to shield the sensor itself from extraneous static. For X-rays, the limit of detection is approximately 5 mRad/min, and for gamma rays the limit is approximately 5 mRad/hr. Through appropriate control of the clearing OFETs, the device is quickly reset to allow for a continuous measurement.
Conference Presentation
© (2021) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Zachary A. Lamport, Marco R. Cavallari, Michael J. Bardash, and Ioannis Kymissis "Organic radiation detectors for real-time dosimetry", Proc. SPIE 11810, Organic and Hybrid Sensors and Bioelectronics XIV, 118100H (3 August 2021); https://doi.org/10.1117/12.2597183
Advertisement
Advertisement
KEYWORDS
Sensors

Radiation dosimetry

Field effect transistors

Control systems

Environmental sensing

Gamma radiation

Ionizing radiation

Back to Top