Characterization of edge effects in precision low-coherence interferometry using broadband light sources

Ch. Taudt; T. Baselt; B. Nelsen; H. Assmann; A. Greiner; E. Koch; P. Hartmann

doi:10.1117/12.2270318

26 June 2017 Characterization of edge effects in precision low-coherence interferometry using broadband light sources

Ch. Taudt, T. Baselt, B. Nelsen, H. Assmann, A. Greiner, E. Koch, P. Hartmann

Proceedings Volume 10329, Optical Measurement Systems for Industrial Inspection X; 1032932 (2017) https://doi.org/10.1117/12.2270318
Event: SPIE Optical Metrology, 2017, Munich, Germany

Abstract

Within this work an alternative approach to precision surface profilometry based on a low-coherence interferometer is presented. Special emphasis is placed on the characterization of edge effects, which influence the measurement result on sharp edges and steep slopes. In contrast to other works, this examination focuses on the comparison of very broadband light sources such as a supercontinuum white-light source (SC; 380 - 1100 nm) and a laser-driven plasma light source (LDP; 200 - 1100 nm) and their influence on the formation of these effects. The interferometer is equipped with one of these broadband light sources and a defined dispersion over a given spectral range. The spectral width of the light sources in combination with the dispersive element defines the possible measurement range and resolution. Instead of detecting the signals only in a one-dimensional manner, an imaging spectrometer on the basis of a high resolution CMOS-camera is set-up. Through the introduction of a defined dispersion, a controlled phase variation in the spectral domain is created. This phase variation is dependent on the optical path difference between both arms and can therefore be used as a measure for the height of a structure which is present in one arm.
The results of measurements on a 100 nm height standard with both selected light sources have been compared. Under consideration of the coherence length of both light sources of 1.58 μm for the SC source and 1.81 m for the LDP source differences could be recorded. Especially at sharp edges, the LDP light source could record height changes with slopes twice as steep as the SC source. Furthermore, it became obvious, that measurements with the SC source tend to show edge effects like batwings due to diffraction. Additional effects on the measured roughness and the flatness of the profile were investigated and discussed.

Citation Download Citation

Ch. Taudt, T. Baselt, B. Nelsen, H. Assmann, A. Greiner, E. Koch, and P. Hartmann "Characterization of edge effects in precision low-coherence interferometry using broadband light sources", Proc. SPIE 10329, Optical Measurement Systems for Industrial Inspection X, 1032932 (26 June 2017); https://doi.org/10.1117/12.2270318

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available